Taking A Break

So since milling tiny internal spaces in aluminum on the Terco without flood coolant seems to not work out, I am redesigning the robot chassis to use Delrin joints with 3d-printed sides reinforced with aluminum tubes.

While I am doing that, I took a detour and did some wood-working that I have been putting off for a while.

Project 1: Serving cutting board

So my first major project at the Makerspace was a cross-grain birch cuting board and I spent more than a month on it. A few months back, I found a piece of cross-grain oak in the “free-to-take” bin. Slightly warped, but OK as a starting point. It was too small to be a primary cutting board (Which is why I assume it was tossed away), but as a serving board it is perfect.

Today I locked it down in the Portal and cut it perfectly flat. Some touching up of the sides and edges and voilá! Buying one of these costs over 1000 sek….

Project 2: Breadboards

No, not that kind! 😛 The original kind that you let bread rise on when baking. Four thin boards exactly the size of a non-stick paper means that we can let a full set of buns rise in our rack while the baking pans remain in the oven meaning we can bake on hot pans, which is a lot better.

Project 3: Camping sideboard

So a few weeks back, we bought two of these magnificent (and also embarrassingly expensive) potable grill racks .

The idea was to use one for actual grilling, and then set up the other one to the side to keep things on. The one thing I dislike about making food in the outdoors is that you never have a flat surface to put things on. Everything is always sort of lying around and leaning against things, and occasionally tipping over when someone (And not always the kids) walks too close.

It sort of works, but the issue with using the grill for this is that the surface isn’t really large enough and firm enough. So now I have made a flat table surface to put on top of the spare grill. More than 43x43cm of solid and flat surface to put things on.

The square groove you see is so that this tabletop will not slide off of the grill. Since I was using the CNC and for some reason it cut a bit deeper than I had planned, I just went with the flow and added some lightening holes to it. The end result is fairly stiff, but really light!

So why exactly 44×44 cm, you might ask (or not..)? Well, there is this thing with CNC that it never goes right on the first attempt. This time, I did a convoluted way of figuring out where my X and Y zero position should be, and not unexpectedly, that complication meant that I made an error of thought and got an offset of about 8mm in X and Y. So I had to trim off about a centimeter on two of the sides to make it symmetric again.

As for why it cut deeper than I had planned, that I do not know. I am thinking that the portal has some tool offset stuff that it is not handling right. Someone should check that…..